News

Finally got a chance to bring the BMW i8 to get the first detail and CQuartz ceramic coated (which should makes it easier to keep it looking clean). Our friend Angel at Clear Cut Detailing was happy to help us out with this project. We and our customers have been using Clear Cut Detailing for years knowing the magic they could do we told them to do the works on the BMW I8. Many hours was invested in this detail with a high expectation from previous example of work done by Clear cut. We were still shocked when we saw...

The BMW I8 looks great from the factory :) but the wheel gap between the tires and fender is not to our liking, so first thing first is to install some lowering springs from H&R which will give us the looks that we are shooting for but still stay practical. Here's what stock ride height looks like To pop the hood on the I8 it does take little bit more work than normal, we are assuming BMW don't want the people to look under the hood where the electric motor sits... There is a little cover that hides the hood...

We finally got the seats in it yay!!! they were pretty much first thing we ordered when we started this project, since they where custom made so it took little over 3 months for them to get here, but we have to say is worth every second of the wait!! The mounting was not too hard (measure 50 times and drill once lol) but to ensure all the seat function perfectly plus have enough leg room for each passenger the arrangement and measurement took almost a full day, the space needed for the sofa bed added additional challenge but thankfully...

We are getting really close to our deadline so we have been pushing extra to get this project completed, this week we putted in alot of hours after business to get it closer to the finish line. We added some LED lighting to light up the cabin and also some behind our custom trim panel to give it a nicer touch. Up first is the added LED by the sliding door to light up the step for getting in and out. We added one on each side :) Than we added some LED stripes for all the window where the...

This week we installed the running board onto the sprinter it should makes getting in and out of the van little easier, the runner board was ordered from Vanguard, we loved the way the look, although in the description it states that does not fit sprinter van with rear AC but we didn't run into any problem installing it on ours. We would say the installation for running board / side step are little more involved than a normal car because there no pre-drill holes under chassis for them. But all in all  wasn't too bad. Here's what the kit...